|
|
|
|
|
|
|
- Used for cutting printed sheets with accuracy
Standard Accessories: 4 edge blade, front back & side gauge, sheet hold-down with built-in finger guard, oil can. |
|
|
|
| - Construction of Body: Body made of resistant steel, welded
for rigidity - Lubrication: Equipped with centralized one shot lubrication system - Slides and Guides: Heavy Duty Cast Iron Slides run on Cast Iron Guides and bearings. Surfaces of slides, guides, slide face and bed are hand scrapped - Crankshaft and Bearings: Eccentric shaft made from carbon steel and ground finished bearings surfaces. Main bearings of hand scrapped walled Nickle Phosphorous Bronze bushes. - Bolster: As required, bolster plates are ground with T slots or Drilled - Pneumatic Friction Clutch and Brake - Suppled with electric control panel and foot switch |
|
 |
Specifications:
|
|
|
 |
- A rotating drum with slots
which separate the punch caps from scrap ring - Power: 0.5 HP motor - Net Weight: approx. 200 kgs. - Dimensions: 0.65 x 1.25 x 0.70 m |
|
|
| - Dies for Pilfer Proof Caps,
Aluminium Seal, Screw Caps, Cap Liner, Pull-Off Caps, Roll-On Caps, Lug
Caps, Shoe Polish Caps, etc. - Single Cavity to Five Cavity Dies - All Die parts made from special quality die steel, hardened and ground finished for longer life - Pillar set made from E.N. Steel duly stress relieved and hand scrapped - Die designed to Cut, Draw and Trim in a single operation |
|
|
|
 |
- Automatic Feed Attachment
provided to the Press to feed aluminium strips onto the die and for
ejection - Two pairs of feed rolls push and pull the strip on the die automatically
|
|
|
 |
- Cast Iron body - Stand fabricated from Mild Steel - Gears made from EN-24 material - All cams, ejector shaft and main shafts aligned on taper roller bearing - Lower tool spindle accurately aligned on needle roller bearing and thrust bearing - Change of adjustable chute and cap feeder very easy - Automatic feeding from chute to lower tool through accurately machined slides - Operation: Knurling, Thread Rolling,
Beading, Perforating, Curling and Trimming |
|
|
| - Designed for High Speed
Production - Caps are fed to the machine by feeder device and delivered to combination tool set. - Wearing parts such as Knurling and Perforating cutters can be quickly replaced, without the need to disassemble the entire unit - The chuck is controlled by a gear and has a system for simple alignment of knurling tool
|
|
|
|
 |
- Designed for High Speed
Production - Caps are fed from the Feeder Device to the Wadding Machine - Wads are fed into the caps by a Vibrator device - Machine is equipped with suitable electrical control panel, inspection conveyor and digital counter for caps
|
| Plastic Stopper Inserting Machine |
|
 -
18 Spindle Rotary Press
|
|
|
|
|
|
|
|
|
|
Maneklal Global Exports |
  |
|
TO OUR PAGE ON SMALL SCALE INDUSTRY PROJECTS |
|
